Cel-Fi GO Mobile Phone Signal Repeater Booster for Telstra Building Pack 3G & 4G
Description
Extends Mobile Phone battery life
Mobile phones use a lot more energy when in poor signal areas. The phone adjusts its internal power to compensate in an attempt to boost the poor signal. As a result the phone will consume a lot more battery power. Using the Cel-Fi system your indoor mobile signal should be high and the battery will last noticeably longer for you to talk. check Facebook and browse the internet.
Eliminate Dropped or Missed Calls
Never miss or lose an important call because of coverage issues again. The Cel-Fi will provide continuous coverage throughout your home or office, so you can be contacted when required. No longer do you have to put up with calls dropping out or terminating during conversation.
PACK INCLUDES:
- Cel-Fi GO Stationary Model
- 'Blackhawk LPDA Yagi 10m LMR240 cable
- Indoor Panel Antenna with 6m RG58 cable (optional ceiling dome antenna)
- 240v Mains Power Supply (optional 12v cigarette plug)
FEATURES
-100dB of system gain
-Includes external and internal antennas
- Locked to Telstra's Mobile Network
- Carrier approved
- Band Selection Button
Blackhawk LPDA YAGI Specifications
- 11 dBi gain across lower bands 698-960 MHz
- 12 dBi gain across upper bands 1710-2700 MHz
- Ruggedised construction for Australian conditions
- Fully welded, powdercoat aluminium design
- Stainless steel mounting clamp included
- 30 cm tail with pre-terminated N Female connector
- Supplied with 10 m of flexible PT240 LSHF cable
- Ideal for high speed 3G and 4G LTE applications.
Ideal for Telstra Next-G and 4GX networks, .
Operating on all 3G and 4G frequencies in Australia and abroad, this high grade antenna can be used in a range of residential, commercial, and industrial mobile broadband applications on any mobile network. This is the ideal external antenna for Cel-Fi repeater systems.
The Blackhawk Wideband LPDA Antenna provides an ideal solution for 3G / 4G voice and data applications. With the rollout of new 3G and 4G frequencies such as 700 MHz 4GX and 2600 MHz 4G, traditional Yagi antennas just haven't been able to keep up. LPDA antennas allow a single antenna to cover all frequencies with the high gain of a Yagi antenna that rural and remote areas demand. This one antenna can be used on any mobile phone network in Australia, in any area without worrying about compatibility.
A Log Periodic Dipole Antenna, or LPDA for short, is a clever antenna design that provides exceptionally wideband performance by phasing a series of elements together, much like an ordinary yagi but with each successive element of a smaller (or larger) length. The result of this clever engineering is an antenna that holds high gain, with good tuning, across the entire cellular frequency range.
SUPPORTED NETWORKS
Telstra, Aldi Mobile,Boost Mobile, Woolworths Connect
IMPORTANT NOTE
Cel-Fi GO will boost a single band at a time (either 3G 850 or 4G 700 or 4G 1800).
30 Day Money Back Guarantee*
If you are not 100% happy
with the performance of this
product it can be returned
within 30 days after purchasing
for a full refund minus any
shipping charges.
Cel-Fi is covered by a 24 month warranty.
® is a registered trade mark of Telstra Corporation Limited. ABN 33 051 775 556